Instructions for the application of glass protector for a mobile device
For better clarity, we bring a clear illustrative guide to correct application
of tempered glass on the smart watch display.
We do everything to make the installation as comfortable as possible
and you can quickly and easily use the comfort and safety
of Tempered Glass Protector.
Package contents
Each Tempered Glass Protector package contains a protective glass, a wet cleaning cloth, a dry cleaning cloth and a dust remover.
For some models, the package may also include a special air bubble squeegee.
Clean your screen
It is very important to have a perfectly cleaned screen area. Remove smudges with a wet cloth, then wipe with a dry cloth until the surface is completely clean and dry.
Do not touch the screen after cleaning.
Dust removal
Dust or other small dirt is likely to get on the clean screen during installation. Use a dust remover to remove them.
To remove dust, do not pull sticker on the screen surface, but peel it off vertically from the surface.
Protective film removal
Slowly remove the protective film
Remove the protective film out of the reach of your smart watch so that dust particles do not return to the screen.
Placing the glass
Slowly place the protective glass on the display, pay attention to the alignment of the placement. The glass starts to adhere to the display.
When gluing, do not touch the bottom adhesive layer.
Finishing process
If air bubbles appear, gently push them from the center towards the edges.
For easier air bubbles removal, we recommend using a special air bubble squeegee. If it is not in the package, you can use any plastic card (bank card, loyalty card…).
Fixing errors A
If dust particles remain under the protective glass, the glass can be peeled off very slowly, the dust can be removed with dust sticker again. When screen is clean you can reglue screen protector.
Lift the glass protector slowly and with a slight incline. The glass may break if peeled off quickly. Be careful when correcting 3D glass protector defects.
Fixing errors B
If air bubbles remain under the protective glass, either in the middle or in the edge, the protective glass can be slowly lifted, then release the bubbles and push towards the edges.
Lift up the glass protector slowly and with a slight incline. The glass may break if peeled off quickly. Be careful when correcting 3D glass protector defects.